Skylla-i Battery Charger

A modern and powerful battery charger that withstands the rigors of an adverse environment: heat, humidity and salt air.

-The right amount of charge for a lead-acid battery: variable absorption time
-BatterySafe mode: preventing damage due to excessive gassing
-Storage mode: less maintenance and aging when the battery is not in use
-Smaller and lighter compared to similar models
-NMEA2000 Canbus connection
-PowerControl: set a maximum shorepower
-Remote Control
-Li-ion (LiFePo4) ready

Use the options in the dropdown menus below to select the Charging Amps and the Number of Outputs required. Click on the “ADDITIONAL INFORMATION” tab below to see the available options for this product.

1.360,001.926,00 ex. VAT

Clear
- +
SKU: N/A Category:

Battery Charger Skylla-i



Skylla-i (1+1): two outputs to charge 2 battery banks
The Skylla-i (1+1) features 2 isolated outputs. The second output, limited to approximately 4 A and with a slightly lower output voltage, is intended to top up a starter battery.

Skylla-i (3): three full current outputs to charge 3 battery banks
The Skylla-i (3) features 3 isolated outputs. All outputs can supply the full rated output current.

Rugged
Aluminium epoxy powder coated cases with drip shield and stainless steel fixings withstand the rigors of an adverse environment: heat, humidity and salt air. Circuit boards are protected with an acrylic coating for maximum corrosion resistance. Temperature sensors ensure that power components will always operate within specified limits, if needed by automatic reduction of output current under extreme environmental conditions.

Flexible
Next to a CAN bus (NMEA2000) interface, a rotary switch, DIP switches and potentiometers are available to adapt the charge algorithm to a particular battery and its conditions of use. Please refer to the manual for a complete overview of the possibilities.

Charging Amps

,

Number Of Outputs

,

Back to top
X
Call Now ButtonCall us